Ti3C2纳米层状材料对废水中Cr（Ⅵ）的光催化去除性能

以Ti₃AlC₂为原料,采用HF刻蚀工艺制备出12种Ti₃C₂纳米层状材料,对其形貌进行了表征,并考察了以其作为光催化剂对废水中Cr（Ⅵ）的处理效果。实验结果表明：HF体积分数为80%、刻蚀时间为48 h时得到的MX-80-48的形貌较好;MX-80-48具有类似石墨烯的二维层状结构,纳米层厚度约20~50 nm,孔径2~10 nm,比表面积14.8 m²/g,在400~700 nm可见光范围内表现出强烈的吸光性;当Cr（Ⅵ）的初始质量浓度为40.00 mg/L、MX-80-48投加量为200 mg/L、pH=2、反应时间4 h（暗反应1 h+光照3 h）时,Cr（Ⅵ）去除率可达100%。     

水处理中微生物絮凝剂产生菌的选育及应用

综述了微生物絮凝剂产生菌筛选和培育方面的研究进展,介绍了微生物絮凝剂在给水和饮用水、乳化液的油水分离、污水处理等领域的应用,以及廉价培养基的探索实践。提出针对影响微生物絮凝剂产生菌生长代谢的环境条件开展深入研究,同时寻找或设计廉价培养基,降低生产成本,推动其工业化应用。     

煤制乙二醇废水预处理装置的工业化调试

针对煤制乙二醇废水含高浓度硝酸盐氮的特点,设计了缺氧膨胀床(AEB)反应器预处理装置,并进行了工业化启动和调试运行,考察了其在反硝化连续流运行条件下的处理效果及工艺参数变化。结果表明,AEB反应器启动后,填料层生物膜挂膜快速且生长稳定。反应器在工业化调试阶段运行稳定,COD和TN的去除率和去除负荷较为稳定。在受到来水冲击后,AEB反应器处理效果稳定,出水可在短期内恢复正常。该技术的系统操控参数范围较广,易于工业化操控运行,在煤制乙二醇废水和其他含高浓度硝酸盐氮废水的处理中具有较大的推广价值。     

城市大气中挥发性有机化合物监测技术进展

挥发性有机物(VOCs)是臭氧及二次有机颗粒物(SOA)的主要前体物。近年来,我国逐步将VOCs纳入大气污染物控制体系。准确可靠的监测技术是大气VOCs研究及控制的重要前提保障。按照采样方法、分析方法 2个方面介绍并讨论了城市大气中VOCs的现有监测方法,较为详细地介绍了几类广泛采用的离线及在线监测技术,简要讨论了目前VOCs监测中存在的一些问题,展望了今后的发展趋势。     

Simple Model of Dissolved Oxygen Consumption in a Bay within High Organic Loading: An Applied Remediation Tool

San Vicente Bay is a coastal shallow embayment in Central Chile with multiple uses, one of which is receiving wastewater from industrial fisheries, steel mill effluents, and domestic sewage. A simulation model was developed and applied to dissolved oxygen consumption by organic residues released into this embayment. Three compartments were established as function of: depth, circulation and outfall location. The model compartments had different volumes, and their oxygen saturation value was used as baseline. The parameters: (a) BOD₅ of the industrial and urban effluents, (b) oxygen demand by organic sediments, (c) respiration, (d) photosynthesis and (e) re-aeration were included in the model. Iteration results of the model showed severe alterations in Compartment 1, with a decrease of 65% in the oxygen below saturation. Compartment 2 showed a small decline (10%) and compartment 3 did not show apparent changes in oxygen values. Measures recommended for remediation were to decrease the BOD₅ loading by 30% in the affected sector. Iteration of the model for 200 h following recommendations derived from the preceding results produced an increase in saturation of 60% (5 ml O₂ L⁻¹), which suggested an improvement of the environmental conditions.     

Fe0/厌氧微生物联合体系处理2,4,6-三氯酚影响因素的研究

利用Fe⁰/厌氧微生物联合体系对2,4,6-三氯酚(2,4,6-TCP)进行降解研究。结果表明，Fe0/厌氧微生物联合体系可以有效降解2,4,6-TCP，Fe⁰与厌氧微生物之间存在明显的协同效应。Fe⁰/厌氧微生物联合体系处理2,4,6-TCP的最优条件为：微生物接种量0.434 g VSS/L，Fe⁰投加量15 g/L，体系初始pH值7.0～8.0。     

Effect of Climatic Factors on the Growth of Representatives of the Genus Pinus (Pinaceae) under Conditions of Introduction

Four introduced and one aboriginal species of the genus Pinus L. have been studied in the middle taiga subzone of southern Karelia. Significant interspecific differences in the dates of onset, cessation, and peak of the growth of shoots and needles have been revealed. It has been shown that their annual increment depends on the rate of growth, rather than on its duration. The dynamics of shoot and needle growth in introduced and aboriginal species, though largely similar, differ in some respects. These differences reflect species-specific responses to hydrothermal conditions in a certain growing season.     

Degradation of polycyclic aromatic hydrocarbons by combined chemical pre-oxidation and bioremediation in creosote contaminated soil

The ability of pre-oxidation to overcome polycyclic aromatic hydrocarbons (PAH) recalcitrance to biodegradation was investigated in creosote contaminated soil. Sand and peat artificially spiked with creosote (quality WEI C) were used as model systems. Ozonation and Fenton-like treatment were proved to be feasible technologies for PAH degradation in soil. The efficiency of ozonation was strongly dependent on the water content of treated soil samples. The removal of PAH by Fenton-like treatment depended on the applied H2O2/soil weight ratio and ferrous ions addition. It was determined that the application of chemical oxidation in sand resulted in a higher PAH removal and required lower oxidant (ozone, hydrogen peroxide) doses. The enhancement of PAH biodegradability by different pre-treatment technologies also depended on the soil matrix. It was ascertained that combined chemical and biological treatment was more efficient in PAH elimination in creosote contaminated soil than either one alone. Thus, the combination of Fenton-like and the subsequent biological treatment resulted in the highest removal of PAH in creosote contaminated sand, and biodegradation with pre-ozonation was found to be the most effective technology for PAH elimination in peat.